Fits GE - Hotpoint & Kenmore 363 Refrigerators.
For Models Not Requiring an RFID Chip.
For Bottom-Freezer Models: Located in the left hand fresh food door (recessed in door flange) or in the fresh food interior on left side wall near the top.
For Side-by-Side Models: Located in the bottom of the fresh food compartment. Access the filter using the flip cover without moving the vegetable pan.
' Free S&H 3 Or More '
WSG-4 Compatible GE RPWF Water Filter Replacement
For Models Not Requiring RFID Chip on back of Filter.
GE - Hotpoint and Kenmore (363. Series) Refrigerators Designed and tested specifically for use in select side-by-side and bottom-freezer refrigerators.
LOCATIONS:
For Bottom-Freezer Refrigerators: Located in the left hand fresh food door (recessed in door flange) or in the fresh food interior on the left side wall near the top.
For Side-by-Side Refrigerators: Located in the bottom of the fresh food compartment. Access the filter using the flip cover without moving the vegetable pan.
Replaces Part Numbers: AP5712603, 2400613, PS8688061, WSG-4, EAP8688061, RPWF.
Compatible GE RPWF Water Filter Replacement
ADVANCED FILTRATION TECHNOLOGY
This WaterSentinel® refrigerator water filter contains a compressed carbon block which provides tremendous capacity to remove and/or reduce impurities and sediment that may be present in your drinking water.
This economical filter will provide you with fresh and clean tasting water and ice cubes and is Guaranteed by WaterSentinel®.
FILTER FEATURES:
Economical alternative to expensive substitutes.
Delivers clean, clear water that looks and tastes great.
Will remove or reduce chlorine taste and odor that may be present in your drinking water.
Designed to provide up to six months of life or 200 gallons.
Does not remove minerals which may be beneficial to health.
Flow Rate: .5 gpm/1.89 lpm
Operating Temperature: 33 - 100°F
Min Operating Pressure: 30 psi
Max Operating Pressure: 100 psi
Measurements Approx. 10 Inches Tall and 1 3/4 Inches Wide.
This filter should not be used with water that is microbiologically unsafe or of unknown quality, without adequate disinfection before and/or after the filter.
This filter has been tested by the manufacturer against ANSI/NSF Standard 42 for the reduction of chlorine taste and odor.
The WSG-4 RPWF Water Filter is found for the following models.
Installation Instructions
1. Remove old cartridge by gently lifting the filter away from housing until first release, and then lift again to remove.
2. Align top of filter with cartridge holder and push until cartridge is fully seated.
3. While continuing to ensure cartridge is fully seated in the holder, gently rotate the filter (inward for Bottom Freezer Models and downward for Side by Side Models) until it can no longer rotate.
4. Run water from the dispenser (approximately 2 gallons or about 5 minutes) to clear any particles and remove air from the system.
