Recommended Products
LG LT800PThis LG LT800P Water Filter is Located at the Ceiling Inside the refrigerator or behind door bin in refrigerator door.
- Login Price
- Buy 1pk for $35.00
- Buy 2pk for $70 and Free S&H
- Buy 3pk for $99 and Free S&H
Price: $36.84
Compatible Fit for LG LT800P ADQ73613401 Water Filter
Description
SAVE 5% - WITH a WFM CUSTOMER ACCOUNT.
Compatible fit for LG LT800P ADQ73613401 Water Filter
Used For some LG and Kenmore (795. Series) French Door or Side by Side Refrigerators with Filter Located in a Flip Down Compartment At The Left Side Rear of Ceiling OR behind lower door bin in left side refrigerator door.
Replaces Part Numbers: ADQ73613408, AGM76550401, AP6836220, PS12714188, EAP12714188, AH12714188, Kenmore 46-9490, 469490, R-9490, 9490.
Installation Instructions (CEILING MOUNT)
1. Locate Filter in a Flip Down Compartment At The Left Side Rear of Ceiling and Pinch sides of the water filter cover to open and pull downward.
2. Rotate Water Filter Downward and turn counterclockwise to remove the water filter. NOTE: If the filter is hard to remove, turn off water supply and relieve pressure at refrigerator door water dispenser before installing new filter.
3. Holding new filter, remove the packaging and end-cap.
4. Insert the pust the new water filter into the filter head and turn it clockwise until it clicks in place.
5. Rotate the water filter up into position and close the cover until it snaps shut.
6. Run water from the dispenser for 5 minutes (about 2.5 gallons) to clear the system and prevent sputtering.
7. Reset your indicator light (if your fridge has one).
Resetting Your Filter Change Indicator
Hold down the LIGHT/FILTER button for 3 seconds.
Installation Instructions (DOOR MOUNT)
1. Open the left side door and remove the lower door bin by grabbing each end with both hands and lift up and out.
2. Swing the old filter out slightly and grab the bottom of the old filter and turn counterclockwise until it releases. NOTE: If the filter is hard to remove, turn off water supply and relieve pressure at refrigerator door water dispenser before installing new filter.
3. Remove the cap cover from the new water filter. Next you place the new filter in the water filter mount and turn the water filter clockwise until it is fully locked in place.
4. Then swing the new filter back into the filter housing and slide your door bin back into place.
6. Run water from the dispenser for 5 minutes (about 2.5 gallons) to clear the system and prevent sputtering.
7. Reset your indicator light (if your fridge has one).
Resetting Your Filter Change Indicator
Hold down the LIGHT/FILTER button for 3 seconds.