Recommended Products
EveryDrop Filter 1Buy new Whorlpool/EveryDrop EDR1RXD1 Filter 1
Located Inside at Right Rear --OR-- Thru the Lower Front Grill.
- SAVE 5% WITH AN ACCOUNT
- Buy 1pk for $35.00
- Buy 2pk for $70.00 and Free S&H
- Buy 3pk for $99.00 and Free S&H
Kenmore 46-9081 Whirlpool W10295370A Water Filter 1
More images
Purchase
Description
SAVE 5% - WITH a WFM CUSTOMER ACCOUNT.
Kenmore 46-9081 Whirlpool W10295370A Water Filter1
Located Inside at Right Rear --OR-- Thru the Lower Front Grill.
Gently lift up on Filter Cover and Filter will automatically Slide Out.
It has a Flow Rate of 0.5 (gpm) and is made of carbon block material. Enjoy crystal clear water and ice when you change your filter every 6-months or 200 gallons. Flush the system with a couple of gallons of water from the dispenser area. Size approx. 7 1/2 inches (length) x 2 inches (diameter).
Used to fix the following Symptons:
Not dispensing water
Ice maker not producing ice
Leaking at filter or water dispenser.
Replaces Part Numbers: W10790813, AP5982535, PS11701542, AH11701542, EAP11701542, 9930, 46-9930, EDR1RXD1, W10295370A, W10295370, AP5672236, W10295370, P4RFWB, W10291030, P8RFKB2L, Kenmore 46-9930, 469930, 9930, 9930P, 04609930000, 46-9081, 469081, 9081.
W10295370A Installation Instructions
Interior Mount
- Locate filter compartment at the right upper corner inside the refrigerator.
- You might have to remove the upper shelf for more room.
- Gently lift up on filter cover and filter will automatically slide out.
- Slide old filter all the way out, noticing the arrow on the end is facing up. (the water will shut off automatically)
- Discard the old filter.
- Line the arrow on end of the new filter upward.
- Gently Push the new filter into the fridge with arrow facing up till it stops.
- As you close the filter cover you will notice that the filter will go in and lock into place.
- Reinstall Shelf (if taken out)
- Reset your change filter light (if your fridge has one)
Mounts Thru Lower Front Grill Mount
- Locate filter at the lower front grill of refrigerator.
- Gently lift up on filter cover and filter will automatically slide out.
- Slide old filter all the way out, noticing the arrow on the end is facing up. (the water will shut off automatically)
- Discard the old filter.
- Line the arrow on end of the new filter upward & Gently Push the new filter into the fridge with arrow facing up till it stops.
- As you close the filter cover you will notice that the filter will go in and lock into place.
- Reset your change filter light (if your fridge has one)
Resetting Your Filter Change Indicator
- Press the light switch (the one that the refrigerator door presses each time you close the door) 5 times within 10 seconds.
- OR: if the refrigerator has a filter button, press and hold it for 5-10 seconds.

Maintenance For Refrigerator Water Filtration System.
- Flush Filter with Water from Dispenser (Approximately 2 gallons) until Water Runs Clear and air is purged from system.
- Write the date of installation on the filter and mark your calander for 4 - 6 months as a reminder to Change Your Filter.
The EDR1RXD1 FILTER1 W10295370A Kenmore 9081 Water Filter Is Found For The Following Models.
INSTALLATION GUIDE for Whirlpool W10295370A Filter1 Kenmore 9081